ADTRAN AOS Version R10.1.0 Command Reference Manual page 245

Command Reference Guide
debug dot11 session
Use the debug dot11 session command to debug all dot11 sessions for the wireless access controller (AC).
Debugging may also be limited to a specified interface. Debug messages are displayed (real time) on the
terminal (or Telnet) screen. Use the no form of this command to disable the debug messages. Variations of
this command include:
debug dot11 session
debug dot11 session interface <interface>
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
interface <interface>
Default Values
By default, all debug messages in AOS are disabled.
Command History
Release 15.1
Usage Examples
The following example activates all dot11 session debug messages:
>enable
#debug dot11 session
2006.12.23 19:56:22 DOT11.Session : AP 1: AP reboot.
2006.12.23 19:56:22 DOT11.Session : AP 1: Control session lost.
2006.12.23 19:56:22 DOT11.Session : AP 1: Control session established.
60000CRG0-35E
Optional. Activates debug messages for the specified interface. Specify an
interface in the format <interface type [slot/port | slot/port.subinterface id |
interface id | interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For
example, for a T1 interface, use t1 0/1; for an Ethernet subinterface, use
eth 0/1.1; for a PPP interface, use ppp 1; for an ATM subinterface, use
atm 1.1; and for a wireless virtual access point, use dot11ap 1/1.1. Type
debug dot11 session interface ? for a complete list of valid interfaces.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
245