ADTRAN AOS Version R10.1.0 Command Reference Manual page 505

Command Reference Guide
show frame-relay multilink
Use the show frame-relay multilink command to display information associated with the Frame Relay
multilink interface. Variations of this command include:
show frame-relay multilink
show frame-relay multilink detailed
show frame-relay multilink <interface>
show frame-relay multilink <interface> detailed
show frame-relay multilink interface frame-relay <subinterface>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<interface>
detailed
interface frame-relay <subinterface>
Default Values
No default values are necessary for this command.
Command History
Release 9.1
Release 17.1
Usage Examples
The following is sample output from the show frame-relay multilink command:
>enable
#show frame-relay multilink
Bundle: frame-relay 1 is DOWN; class A bundle
Near-end BID: MFR1; Far-end BID: unknown
60000CRG0-35E
83.
Optional. Specifies the display of information for a specific
interface. Enter the show frame-relay multilink ? command for
a complete list of interfaces.
Optional. Displays more detailed information.
Optional. Displays detailed fragmentation statistics for the
specified Frame Relay subinterface. Subinterfaces are expressed
in the format interface id.subinterface id (for example, fr 1.16).
Command was introduced.
Command was expanded to include the modifiers begin,
exclude, and include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
505