ADTRAN AOS Version R10.1.0 Command Reference Manual page 537

Command Reference Guide
show ip access-lists
Use the show ip access-lists command to display all configured Internet Protocol version 4 (IPv4) access
control lists (ACLs) in the system. Variations of this command include:
show ip access-lists
show ip access-lists <ipv4 acl name>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<ipv4 acl name>
Default Values
No default values are necessary for this command.
Command History
Release 2.1
Release 17.1
Functional Notes
The show ip access-lists command displays all configured IPv4 ACLs in the system. All entries in the
IPv4 ACL are displayed, and a counter indicating the number of packets matching the entry is listed.
Usage Examples
The following is sample output from the show ip access-lists command, and displays information for IPv4
ACLs:
>enable
#show ip access-lists
Standard IP access list MatchAll
permit host 10.3.50.6 (0 matches)
permit 10.200.5.0 wildcard bits 0.0.0.255 (0 matches)
Extended IP access list UnTrusted
deny icmp 10.5.60.0 wildcard bits 0.0.0.255 any source-quench (0 matches)
deny tcp any any (0 matches)
60000CRG0-35E
Optional. Specifies a particular IPv4 ACL to display.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
537