ADTRAN AOS Version R10.1.0 Command Reference Manual page 764

Command Reference Guide
show system mtu
Use the show system mtu command to display the current system maximum transmission unit (MTU)
setting.
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 17.6
Usage Examples
The following is sample output from the show system mtu command:
>enable
#show system mtu
MTU size is 9216 bytes
60000CRG0-35E
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
764