ADTRAN AOS Version R10.1.0 Command Reference Manual page 520

Command Reference Guide
Default Values
No default values are necessary for this command.
Command History
Release 1.1
Release 6.1
Release 10.1
Release 11.1
Release 17.1
Release 17.5
Release A4.01
Release A5.01
Release 18.3
Functional Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
page 837).
Usage Examples
The following is sample output from the show interfaces description command:
>enable
#show interfaces description
Interface Status
eth 0/1 Admin Up
eth 0/2 Admin Up
eth 0/3 Admin Up
eth 0/4 Admin Up
eth 0/5 Admin Up
eth 0/6 Admin Up
eth 0/7 Admin Up
eth 0/8 Admin Up
eth 0/9 Admin Up
eth 0/10 Admin Up
eth 0/11 Admin Up
eth 0/12 Admin Up
eth 0/13 Admin Up
60000CRG0-35E
Command was introduced.
Command was expanded to include the switchport parameter.
Command was expanded to include the vlans parameter.
Description and status parameters were introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Command was expanded to include the gigabit-switchport parameter.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface.
Command was expanded to include the realtime parameter.
Command was expanded to include the extended parameter.
Protocol Description
Line Up Desk 1
Line Up Desk 2
Line Up Desk 3
Line Up Desk 4
Line Up Desk 5
Line Up Desk 6
Line Up Desk 7
Line Down Desk 8
Line Up Desk 9
Line Up Desk 10
Line Up Desk 11
Line Up Desk 12
Line Up Desk 13
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
terminal length <number> on
520