ADTRAN AOS Version R10.1.0 Command Reference Manual page 628

Command Reference Guide
show ipv6 dhcp pool
Use the show ipv6 dhcp pool command to display the information about each configured Dynamic Host
Control Protocol version 6 (DHCPv6) pool and the general statistics of the current pool assignments.
Variations of this command include:
show ipv6 dhcp pool
show ipv6 dhcp pool <name>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<name>
Default Values
No default values necessary for this command.
Command History
Release R10.1.0
Usage Examples
The following example displays the configuration of all DHCPv6 server pools:
>enable
#show ipv6 dhcp pool
Pool POOL
Link Addresses:
22::/64
22::/96
Client Identifiers:
112233445566 2
112233445566
Address Prefixes:
22::/64 lifetime 60 30
Host client-identifier AABBCCDD
Hostname: server1
60000CRG0-35E
Optional. Limits the command output to only the statistics for the specified
DHCPv6 server pool.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
628