Show Flash - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show flash

Use the show flash command to display a list of all files currently stored in flash memory. Variations of
this command include:
show flash
show flash <filename>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<filename>
Default Values
No default values are necessary for this command.
Command History
Release 1.1
Release 17.1
Usage Examples
The following is sample output from the show flash command:
>enable
#show flash
Files:
245669 010100boot.biz
1141553 new.biz
821 startup-config
1638 startup-config.old
1175679 020016.biz
821 startup-config.bak
2572304 bytes used 4129776 available 6702080 total
System image file is "020100.biz"
60000CRG0-35E
Optional. Displays details for a specified file located in flash memory. Enter
a wildcard (such as *.biz) to display the details for all files matching the
entered pattern.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
500