ADTRAN AOS Version R10.1.0 Command Reference Manual page 463

Command Reference Guide
show debugging
Use the show debugging command to display a list of all activated debug message categories. Variations
of this command include:
show debugging
show debugging saved-filters
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
saved-filters
Default Values
No default values are necessary for this command.
Command History
Release 1.1
Release 17.1
Release 17.4
Usage Examples
The following is sample output from the show debugging command:
>enable
#show debugging
debug access-list MatchAll
debug firewall
debug ip rip
debug frame-relay events
debug frame-relay llc2
debug frame-relay lmi
60000CRG0-35E
Optional. Displays the last debug filters saved using the command
save on page 356.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Command was expanded to include the saved-filters keyword.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
debug
463