Show Ip Igmp Interface - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show ip igmp interface

Use the show ip igmp interface command to display multicast-related information per-interface. If no
interface is specified, this command shows information for all interfaces. Variations of this command
include:
show ip igmp interface
show ip igmp interface <interface>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<interface>
Default Values
No default values are necessary for this command.
Command History
Release 7.1
Release 9.1
Release 17.1
Release A5.01
60000CRG0-35E
Optional. Displays information for a specific interface type. Specify an
interface in the format <interface type [slot/port | slot/port.subinterface id |
interface id | interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For
example, for a T1 interface, use t1 0/1; for an Ethernet subinterface, use
eth 0/1.1; for a PPP interface, use ppp 1; for an ATM subinterface, use
atm 1.1; and for a wireless virtual access point, use dot11ap 1/1.1. Enter
the show ip igmp interface ? command for a complete list of interfaces.
Command was introduced.
Command was expanded to include the high level data link control (HDLC)
and tunnel interfaces.
Command was expanded to include the modifiers begin, exclude, and
include.
Command was expanded to include the Gigabit Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
557