ADTRAN AOS Version R10.1.0 Command Reference Manual page 531

Command Reference Guide
show interfaces dot11ap
Use the show interfaces dot11ap command to display information related to a wireless access point (AP),
radio, or virtual access point (VAP) interface. Variations of this command include:
show interfaces dot11ap [<ap> | <ap/radio> | <ap/radio.vap>]
show interfaces dot11ap <ap> control-protocol
show interfaces dot11ap [<ap/radio> | <ap/radio.vap>] dot11
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<ap>
</radio>
<.vap>
control-protocol
dot11
The radio must be specified in the format <ap/radio> (for example, 2/1 indicates radio 1
on access point 2). The virtual access point must be specified in the format
<ap/radio.vap> (for example, 2/1.1 indicates virtual access point 1 on radio 1 on access
point 2).
Default Values
No default values are necessary for this command.
Command History
Release 15.1
Release 17.1
60000CRG0-35E
Specifies the AP. Range is 1 to 8.
Specifies the radio associated with the AP. Range is 1 to 2.
Specifies the VAP associated with the radio. Range is 1 to 8.
Optional. Displays properties of the control protocol for the AP.
Optional. Displays counters of an 802.11 radio's VAPs.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
531