ADTRAN AOS Version R10.1.0 Command Reference Manual page 363

Command Reference Guide
debug snmp packets
Use the debug snmp packets command to enable debug output from local Simple Network Management
Protocol (SNMP) traffic. Debug messages are displayed (real time) to the terminal (or Telnet) screen.
When SNMP packets ingress or egress the unit (local traffic only), the traffic is displayed in a partially
decoded form. Use the no form of this command to disable the debug messages.
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
No subcommands.
Default Values
By default, all debug messages in AOS are disabled.
Command History
Release 14.1
Usage Examples
The following is an example of debug output for snmp packets:
>enable
#debug snmp packets
#SNMP V1 RX: GET-NEXT Request PDU from 10.23.1.157:2922 (community=public)
request id=3, error status=0, error index=0
max repetitions=0, non repetitions=0
VarBinds:
OID=1.3.6.1.2.1.1.3
value=empty
#SNMP V1 TX: GET Response PDU to 10.23.1.157:2922 (community=public)
request id=3, error status=0, error index=0
max repetitions=1, non repetitions=0
VarBinds:
OID=1.3.6.1.2.1.1.3.0
value=410825
60000CRG0-35E
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
363