ADTRAN AOS Version R10.1.0 Command Reference Manual page 220

Command Reference Guide
debug access-list <name>
Use the debug access-list command to activate debug messages (for a specified list) associated with access
control list (ACL) operation. Debug messages are displayed (real time) on the terminal (or Telnet) screen.
Use the no form of this command to disable the debug messages.
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
<name>
Default Values
By default, all debug messages in AOS are disabled.
Command History
Release 6.1
Functional Notes
The debug access-list command provides debug messages to aid in troubleshooting ACL issues. These
debug messages are populated by traffic matches that occur when traffic is filtered through the ACL. The
ACL must have the logging feature enabled in order to populate the debug message. To enable ACL
match logging, refer to the
Usage Examples
The following is sample output of debug messages for the ACL labeled MatchAll:
>enable
#debug access-list MatchAll
2009.06.09 14:15:03 ACCESS_LIST.MatchAll
2009.06.09 14:15:13 ACCESS_LIST.MatchAll
2009.06.09 14:15:57 ACCESS_LIST.MatchAll
60000CRG0-35E
Specifies a configured ACL.
Command was introduced.
IPv4 Access Control List Command Set on page
Copyright © 2012 ADTRAN, Inc.
permit host 192.168.0.1 log (1 matches)
permit host 192.168.0.1 log (3 matches)
permit host 192.168.0.1 log (1 matches)
Enable Mode Command Set
3126.
220