ADTRAN AOS Version R10.1.0 Command Reference Manual page 1185

Command Reference Guide
ipv6 dhcp address limit <number>
Use the ipv6 dhcp address limit command to specify the maximum number of Internet Protocol version 6
(IPv6) addresses that can be assigned by the Dynamic Host Control Protocol version 6 (DHCPv6) server.
This command limits the number of addresses assigned by the DHCPv6 server to ensure that the AOS unit
does not run out of memory. Use the no form of this command to reset the count to the default value.
Syntax Description
<number>
Default Values
By default, only a certain number of addresses can be assigned by the DHCPv6 server. This number
varies by AOS product.
Command History
Release R10.1.0
Usage Examples
The following example changes the maximum number of IPv6 addresses that can be assigned by the
DHCPv6 server to 2000:
(config)#ipv6 dhcp address limit 2000
60000CRG0-35E
Specifies the number of IPv6 addresses that can be assigned. Valid range
is 1 to 10000. This maximum number is product-specific, and is equivalent
to the default value on the AOS unit.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1185