ADTRAN AOS Version R10.1.0 Command Reference Manual page 393

Command Reference Guide
The following is a list of output messages from the ping command:
!
-
$
X
?
*
The following is a list of available extended ping fields with descriptions:
Extended Commands
Source Address
Data Pattern
Sweep Range of Sizes
Sweep Min Size
Sweep Max Size
Sweep Interval
Verbose Output
VRF on AOS products allows a single physical router to be partitioned into multiple virtual routers. Each
router instance has its own route table and interface assignments. Beginning with Release 16.1, all AOS
routers supporting multiple VRF instances (multi-VRF) have an unnamed default VRF instance regardless
of whether multi-VRF is configured. Therefore, executing the abovementioned commands without
specifying a VRF will only affect the default unnamed VRF.
Usage Examples
The following is an example of a successful ping command:
>enable
#ping
VRF Name [-default-]:
Target IP address:192.168.0.30
Repeat count [5]:5
Datagram Size [100]:100
Timeout in seconds [2]:2
Wait interval in milliseconds [100]:100
Extended Commands? [n]:n
Type CTRL+C to abort.
Legend: '!' = Success, '?' = Unknown host, '$' = Invalid host address
60000CRG0-35E
Success
Destination Host Unreachable
Invalid Host Address
TTL Expired in Transit
Unknown Host
Request Timed Out
Specifies whether additional commands are desired for more ping
configuration parameters. Answer yes (y) or no (n).
Specifies the IPv4 address to use as the source address in the ECHO_REQ
(or interface) packets.
Specifies an alphanumerical string to use (the ASCII equivalent) as the data
pattern in the ECHO_REQ packets.
Varies the sizes of the ECHO_REQ packets transmitted.
Specifies the minimum size of the ECHO_REQ packet. Valid range is 0 to
1488.
Specifies the maximum size of the ECHO_REQ packet. Valid range is the
sweep minimum size to 1448.
Specifies the interval used to determine packet size when performing the
sweep. Valid range is 1 to 1448.
Specifies an extended results output.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
393