ADTRAN AOS Version R10.1.0 Command Reference Manual page 841

Command Reference Guide
mep <mep id>
sorted
timeout <timeout>
ttl <value>
Default Values
By default, the timeout value is set to 5 seconds.
By default, the ttl value is set to 5 seconds.
Command History
Release 17.4
Release A4.01
Release A5.01
Functional Notes
The traceroute ethernet command can be issued from both the Basic and Enable modes.
If the MEP ID is used as the target, the remote MEP must exist in the MEP CCM database (meaning the
remote MEP is transmitting valid CCMs) so that the MEP ID can be translated to the MAC address before
the linktrace message is transmitted.
Both the domain <domain name> and association <association name> parameters are not required if the
source MEP ID of the MEP is specified and unique through the AOS device.
If the domain and association of the transmitting MEP are specified, and there is only one MEP in that
domain or association, or if there is only one MEP configured on the unit, the mep <mep id> parameter is
not required.
For more information regarding Ethernet OAM CFM and its operation on AOS products, refer to the
Ethernet OAM CFM in AOS configuration guide available online at
(article number 3013).
60000CRG0-35E
Optional. Specifies the MEP ID of the transmitting MEP. MEP ID
range is 1 to 8191.
Optional. Specifies the traceroute utility waits until all traceroute
results have been received and sorted by hop count before
displaying them.
Optional. Specifies the time that the MEP will wait for a
response to the linktrace message. Range is 0 to 60 seconds.
Optional. Specifies the time to live (TTL) field of the linktrace
message. Range is 0 to 255.
Command was introduced.
Command was expanded to include the Metro Ethernet Forum
(MEF) Metro Ethernet interface and the Gigabit Switchport
interface.
Command was expanded to include the Gigabit Ethernet
interface.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
https://supportforums.adtran.com
841