ADTRAN AOS Version R10.1.0 Command Reference Manual page 795

Command Reference Guide
show voice extensions
Use the show voice extensions command to display all of the current voice extensions and their status.
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 10.1
Release 17.1
Usage Examples
The following example displays all extensions and the status of the extension:
>enable
#show voice extension
AccountID Idle/Ring/Busy
---------------------------------------------------------------------------------------
T01 Idle
T06 Idle
T02 Idle
5200 Idle
6000 Idle
6001 Idle
6002 Idle
6003 Idle
T03 Idle
2 Idle
1234 Idle
60000CRG0-35E
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Available DND FWD
* - -
* - -
* - -
* - -
* - -
* - -
* - -
* - -
* - -
* - -
* - -
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
795