ADTRAN AOS Version R10.1.0 Command Reference Manual page 1053

Command Reference Guide
ip mgcp rfc2833-signaling
Use the ip mgcp rfc2833-signaling command to enable the transmission and reception of ABCD signal
bits via RFC 2833 packets. Use the no form of this command to disable ABCD signaling.
This command should only be used with gateways configured to send ABCD signaling bits
out-of-band for TDM passthrough. Configuring this command when it is not needed will
likely cause undesired operation.
Syntax Description
No subcommands.
Default Values
By default, ABCD signaling is disabled.
Command History
Release A2
Usage Examples
The following example enables ABCD signaling:
(config)#ip mgcp rfc2833-signaling
60000CRG0-35E
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1053