Table of Contents
Advertisement
Command Reference Guide
ramdisk
startup-config
usbdrive0
Default Values
No default values are necessary for this command.
Command History
Release 1.1
Release 12.1
Release 14.1
Release A2.04
Release 17.7
Release A4.01
Release 18.2
Usage Examples
The following example erases the startup configuration file stored in flash memory:
>enable
#erase startup-config
If a new startup configuration file is not specified before cycling the power on the unit, AOS will initialize
using a blank configuration.
The following example erases all files located on the installed CompactFlash card:
>enable
#erase file-system cflash
This will erase ALL files on compact flash. Proceed? [y/n]
The following example erases all files located in the system flash memory:
>enable
#erase file-system flash
WARNING! You are about to erase all files on the flash file system.
This includes all firmware images and configuration files. This cannot be undone.
This will erase ALL files on flash. Proceed? [y/n]
60000CRG0-35E
Specifies the location of the file to erase as the volatile RAM disk.
Erases the startup configuration file stored in flash memory.
Specifies the location of the file to erase as the USB flash drive memory.
Command was introduced.
Command was expanded to include the dynvoice-config parameter.
Command was expanded to include the file-system cflash parameter.
Command was expanded to include the file-system flash parameter.
Command was expanded to include the ramdisk parameter.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface.
Command was expanded to include the USB flash drive memory.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
385
Advertisement
Table of Contents
