ADTRAN AOS Version R10.1.0 Command Reference Manual page 786

Command Reference Guide
Command History
Release 5.1
Release 10.1
Release 15.1
Release 17.1
Functional Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
page 837).
Usage Examples
The following is sample output from the show vlan command:
>enable
#show vlan
VLAN Name
------------------ --------------------
- 1 Default
2 accounting
3 VLAN0003
VLAN Type
------------------ ---------------
- 1 enet
2 enet
3
60000CRG0-35E
Command was introduced.
The realtime display parameter was introduced.
The realtime display parameter was added to show vlan id and show vlan
name.
Command was expanded to include the modifiers begin, exclude, and
include.
Status Ports
-------------- -----------
active eth 0/5, eth 0/6, eth 0/8, eth 0/13, eth 0/14, eth 0/15,
eth 0/16, eth 0/17, eth 0/18, eth 0/19, eth 0/20,
eth 0/21, eth 0/22, eth 0/23, eth 0/24, giga-eth 0/1,
giga-eth 0/2
active eth 0/1, eth 0/2
active eth 0/3, eth 0/4, eth 0/7, eth 0/9, eth 0/10, eth 0/11,
eth 0/12
MTU
--------------
1500
1500
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
terminal length <number> on
786