ADTRAN AOS Version R10.1.0 Command Reference Manual page 419

Command Reference Guide
show atm traffic interface atm <interface>
Use the show atm traffic interface atm command to display traffic information specific to the
asynchronous transfer mode (ATM) interface.
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<interface>
Default Values
No default values are necessary for this command.
Command History
Release 8.1
Release 17.1
Usage Examples
The following is sample output from the show atm traffic command from ATM interface 1:
>enable
#show atm traffic interface atm 1
atm 1 is UP, line protocol is UP
BW 896 Kbit/s
16 maximum active VCCs, 16 VCCs per VP, 1 current VCCs
Queueing strategy: Per VC Queueing
5 minute input rate 32 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
19 packets input, 1357 bytes
0 pkts discarded, 0 error pkts, 0 unknown protocol pkts
45 cells received, 0 OAM cells received
0 packets output, 0 bytes
0 tx pkts discarded, 0 tx error pkts 0 internal tx error pkts
0 cells sent, 0 OAM cells sent
60000CRG0-35E
Specifies an ATM port number. Specify an ATM interface (valid range is 1 to
1023) or a subinterface in the format <interface id.subinterface id> (for
example, 1.1).
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
419