ADTRAN AOS Version R10.1.0 Command Reference Manual page 721

Command Reference Guide Enable Mode Command Set
show running-config
Use the show running-config command to display all the nondefault parameters contained in the current
Internet Protocol version 4 (IPv4) running configuration file. Specific portions of the running
configuration may be displayed, based on the command entered. Variations of this command include the
following:
show running-config
show running-config checksum
show running-config hmr
show running-config hmr policy
show running-config hmr policy <name>
show running-config hmr policy <name> verbose
show running-config hmr policy verbose
show running-config hmr rule-set
show running-config hmr rule-set <name>
show running-config hmr rule-set <name> verbose
show running-config hmr rule-set verbose
show running-config interface <interface>
show running-config interface <interface> verbose
show running-config ip access-lists
show running-config ip access-lists verbose
show running-config ip-crypto
show running-config ip-crypto verbose
show running-config ip mgcp
show running-config ip mgcp verbose
show running-config ip nat pool
show running-config ip nat pool verbose
show running-config ip rtp
show running-config ip rtp verbose
show running-config ip sdp
show running-config ip sdp verbose
show running-config ip security monitor
show running-config ip security monitor verbose
show running-config ip sip
show running-config ip sip verbose
show running-config ip sip proxy failover
show running-config ip sip proxy failover verbose
show running-config ip sip proxy user-template <name>
show running-config ip sip proxy user-template <name> verbose
show running-config ip policy-class
show running-config ip policy-class verbose
show running-config ip urlfilter
show running-config mef
show running-config mef verbose
show running-config probe
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 721