ADTRAN AOS Version R10.1.0 Command Reference Manual page 503

Command Reference Guide
show frame-relay fragment
Use the show frame-relay fragment command to display detailed fragmentation statistics for Frame
Relay subinterfaces with FRF.12 fragmentation enabled. Variations of this command include:
show frame-relay fragment
show frame-relay fragment interface frame-relay <subinterface>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
interface frame-relay <subinterface>
Default Values
No default values are necessary for this command.
Command History
Release 6.1
Release 17.1
Usage Examples
The following are sample outputs from various show frame-relay fragment commands:
>enable
#show frame-relay fragment
interface dlci frag_size
fr 1.1 17 100
fr 1.2 18 200
60000CRG0-35E
Optional. Displays detailed fragmentation statistics for the specified
Frame Relay subinterface. Subinterfaces are expressed in the
format interface id.subinterface id (for example, fr 1.16).
Command was introduced.
Command was expanded to include the modifiers begin,
exclude, and include.
rx_frag tx_frag dropped_frag
46 48 0
42 21 0
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
503