ADTRAN AOS Version R10.1.0 Command Reference Manual page 435

Command Reference Guide
show bgp neighbors
Use the show bgp neighbors command to display information for the specified Border Gateway Protocol
(BGP) neighbor. Variations of this command include the following:
show bgp any-vrf ipv4 neighbors
show bgp any-vrf ipv4 neighbors <ipv4 address>
show bgp any-vrf ipv4 neighbors <ipv4 address> advertised-routes
show bgp any-vrf ipv4 neighbors <ipv4 address> received-routes
show bgp any-vrf ipv4 neighbors <ipv4 address> routes
show bgp ipv4 neighbors
show bgp ipv4 neighbors <ipv4 address>
show bgp ipv4 neighbors <ipv4 address> advertised-routes
show bgp ipv4 neighbors <ipv4 address> received-routes
show bgp ipv4 neighbors <ipv4 address> routes
show bgp vrf <name> ipv4 neighbors
show bgp vrf <name> ipv4 neighbors <ipv4 address>
show bgp vrf <name> ipv4 neighbors <ipv4 address> advertised-routes
show bgp vrf <name> ipv4 neighbors <ipv4 address> received-routes
show bgp vrf <name> ipv4 neighbors <ipv4 address> routes
show bgp any-vrf ipv6 neighbors
show bgp any-vrf ipv6 neighbors <ipv6 address>
show bgp any-vrf ipv6 neighbors <ipv6 address> advertised-routes
show bgp any-vrf ipv6 neighbors <ipv6 address> received-routes
show bgp any-vrf ipv6 neighbors <ipv6 address> routes
show bgp ipv6 neighbors
show bgp ipv6 neighbors <ipv6 address>
show bgp ipv6 neighbors <ipv6 address> advertised-routes
show bgp ipv6 neighbors <ipv6 address> received-routes
show bgp ipv6 neighbors <ipv6 address> routes
show bgp vrf <name> ipv6 neighbors
show bgp vrf <name> ipv6 neighbors <ipv6 address>
show bgp vrf <name> ipv6 neighbors <ipv6 address> advertised-routes
show bgp vrf <name> ipv6 neighbors <ipv6 address> received-routes
show bgp vrf <name> ipv6 neighbors <ipv6 address> routes
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
60000CRG0-35E
83.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
435