Show Arp - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show arp

Use the show arp command to display the Address Resolution Protocol (ARP) table. Variations of this
command include:
show arp
show arp realtime
show arp vrf <name>
show arp vrf <name> realtime
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Using the realtime argument for this command can adversely affect the performance or
your unit.
Syntax Description
realtime
vrf <name>
Default Values
No default values are necessary for this command.
Command History
Release 1.1
Release 10.1
Release 16.1
Release 17.1
60000CRG0-35E
Optional. Displays full-screen output in real time. Refer to the Functional
Notes below for more information.
Optional. Displays information only for the specified VPN routing and
forwarding (VRF). If a VRF is not specified, the default VRF is assumed.
Command was introduced.
The realtime display parameter was introduced.
Command was expanded to include the vrf parameter.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
415