ADTRAN AOS Version R10.1.0 Command Reference Manual page 620

Command Reference Guide
show ipv6 access-list
Use the show ipv6 access-list command to display all configured Internet Protocol version 6 (IPv6) access
control lists (ACLs) in the system. Variations of this command include:
show ipv6 access-list
show ipv6 access-list <ipv6 acl name>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<ipv6 acl name>
Default Values
No default values are necessary for this command.
Command History
Release 18.1
Functional Notes
The show ipv6 access-list command displays all configured IPv6 ACLs in the system. All entries in the
IPv6 ACL are displayed, and a counter indicating the number of packets matching the entry is listed.
Usage Examples
The following is sample output from the show ipv6 access-list command, and displays information for the
IPv6 ACL Privatev6:
>enable
#show ipv6 access-list Privatev6
Extended IPv6 access-list Privatev6
deny tcp any eq telnet any (0 matches)
deny tcp any any eq telnet (0 matches)
permit ipv6 any host 2000:1::1 (0 matches)
permit ipv6 host 2000:2::1 any (0 matches)
permit icmpv6 any any (0 matches)
60000CRG0-35E
Optional. Specifies a particular IPv6 ACL to display.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
620