ADTRAN AOS Version R10.1.0 Command Reference Manual page 461

Command Reference Guide
show crypto map
Use the show crypto map command to display information regarding crypto map settings. Variations of
this command include the following:
show crypto map
show crypto map interface <interface>
show crypto map <name>
show crypto map <name> <number>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
interface <interface>
<name>
<number>
Default Values
No default values are necessary for this command.
Command History
Release 4.1
Release 17.1
Release A4.01
60000CRG0-35E
Optional. Displays the crypto map settings for the specified interface.
Specify an interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface id | ap |
ap/radio | ap/radio.vap]>. For example, for a T1 interface, use t1 0/1; for an
Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; for an
ATM subinterface, use atm 1.1; and for a wireless virtual access point, use
dot11ap 1/1.1. Type show crypto map interface ? for a complete list of
valid interfaces.
Optional. Specifies a specific crypto map name.
Optional. Specifies a specific crypto map number.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
461