ADTRAN AOS Version R10.1.0 Command Reference Manual page 534

Command Reference Guide
show interfaces efm-group
Use the show interfaces efm-group command to view the interface statistics for the specified Ethernet in
the first mile (EFM) group. Variations of this command include:
show interfaces efm-group all
show interfaces efm-group all connections
show interfaces efm-group <group number>
show interfaces efm-group <group number> connections interval 15-minute <value>
show interfaces efm-group <group number> connections interval 24-hour <value>
show interfaces efm-group <group number> interval 15-minute <value>
show interfaces efm-group <group number> interval 24-hour <value>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
all
<group number>
connections
interval 15-minute
interval 24-hour
<value>
Default Values
No default values are necessary for this command.
Command History
Release A4.01
60000CRG0-35E
Displays statistics for all EFM groups.
Displays statistics for a single EFM group. Range is 1 to 1024.
Optional. Displays the statistics for the connected interfaces.
Optional. Displays the statistics for a 15-minute period in the last 24 hours.
Optional. Displays the statistics for a 24-hour period in the last 7 days.
Specifies which 15-minute period in the last 24 hours or which 24-hour
period in the last 7 days is displayed. Range for 15-minute periods is 1 to 4;
range for 24-hour periods is 1 to 7.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
534