ADTRAN AOS Version R10.1.0 Command Reference Manual page 479

Command Reference Guide
show dot11 clients
Use the show dot11 clients command to display stations associated with all wireless access points (APs).
Variations of this command include the following:
show dot11 clients interface dot11ap <ap interface>
show dot11 clients mac-address <mac address>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
interface dot11ap
<ap interface>
mac-address
<mac address>
Default Values
No default values are necessary for this command.
Command History
Release 15.1
Release 17.1
Usage Examples
The following command initiates a request to display a list of clients for AP interface 1.
>enable
#show dot11 clients interface dot11ap 1
Wireless Access Point Clients:
Ap Station MAC-Address
------ -------------------
1 00:40:96:AB:3B:5E
60000CRG0-35E
Displays stations associated with APs by interface.
Specifies AP interface number. Range is 1 to 8.
Displays stations associated with APs by medium access control (MAC)
address.
Specifies a valid client 48-bit MAC address. MAC addresses should be
expressed in the following format xx:xx:xx:xx:xx:xx (for example,
00:A0:C8:00:00:01).
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
479