ADTRAN AOS Version R10.1.0 Command Reference Manual page 345

Command Reference Guide
debug port-auth
Use the debug port-auth command to generate debug messages used to aid in troubleshooting problems
during the port authentication process. Debug messages are displayed (real time) on the terminal (or
Telnet) screen. Use the no form of this command to disable the debug messages. Variations of this
command include the following:
debug port-auth
debug port-auth auth-sm
debug port-auth bkend-sm
debug port-auth general
debug port-auth packet
debug port-auth packet [both | tx | rx]
debug port-auth reauth-sm
debug port-auth supp-sm
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
auth-sm
bkend-sm
general
packet both
packet rx
packet tx
reauth-sm
supp-sm
Default Values
By default, all debug messages in AOS are disabled.
Command History
Release 9.1
Release 10.1
Release 13.1
60000CRG0-35E
Optional. Displays AuthPAE-state machine information.
Optional. Displays backend-state machine information.
Optional. Displays configuration changes to the port authentication system.
Optional. Displays packet exchange information in both receive and
transmit directions.
Optional. Displays packet exchange information in the receive-only
direction.
Optional. Displays packet exchange information in the transmit-only
direction.
Optional. Displays reauthentication-state machine information.
Optional. Displays supplicant-state machine information.
Command was introduced.
New options were introduced.
New options were introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
345