Show Stack - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show stack

Use the show stack command to view the status of all the switches configured for stacking. Displays the
mode of the switch as either master or member. If the mode is master, this command also gives the status
of the stack members. Variations of this command include:
show stack
show stack candidates
show stack candidates realtime
show stack realtime
show stack topology
show stack topology realtime
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Using the realtime argument for this command can adversely affect the performance of
your unit.
Syntax Description
candidates
topology
realtime
Default Values
No default values are necessary for this command.
Command History
Release 8.1
Release 10.1
Release 17.1
60000CRG0-35E
Optional. Displays all units that have registered with this stack master. This
option is only available on a switch configured as a stack master.
Optional. Displays the stack topology. This option is only available on a
switch configured as a stack master.
Optional. Displays full-screen output in real time. Refer to Functional Notes
below for more information.
Command was introduced.
The realtime display parameter was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
756