ADTRAN AOS Version R10.1.0 Command Reference Manual page 626

Command Reference Guide
show ipv6 dhcp conflict
Use the show ipv6 dhcp conflict command to display detailed information about any addresses deemed as
conflicting by a Dynamic Host Control Protocol version 6 (DHCPv6) client or by the DHCPv6 server
when the client is pinged. Variations of this command include:
show ipv6 dhcp conflict
show ipv6 dhcp conflict <ipv6 address>
show ipv6 dhcp conflict vrf <name>
show ipv6 dhcp conflict vrf <name> <ipv6 address>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<ipv6 address>
vrf <name>
Default Values
No default values necessary for this command.
Command History
Release R10.1.0
Usage Examples
The following example displays all DHCPv6 conflicting IPv6 addresses:
>enable
#show ipv6 dhcp conflict
Address/Prefix
1111:2222:333:4444:5555:66:7777/128
1111:2222:333:4444:5555:66:7777/128
60000CRG0-35E
Optional. Limits the output to conflicting addresses for the specified client
address. IPv6 addresses should be expressed in colon hexadecimal format
(for example, 2001:DB8:1::1).
Optional. Limits the output to a nondefault VPN routing and forwarding
(VRF) instance. If no VRF is specified, conflicting addresses on all VRF
instances are displayed.
Command was introduced.
Reason
PING
DECL
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
TTL (seconds)
44
56
626