ADTRAN AOS Version R10.1.0 Command Reference Manual page 713

Command Reference Guide
show queue <interface>
Use the show queue command to display conversation information associated with an interface queue.
This command shows summary and per-conversation information. The per-conversation details are nly
displayed if the interface has sufficient traffic to be congested and packets are being held in the interface
queue. Variations of this command include:
show queue <interface>
show queue <interface> child
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<interface>
child
Default Values
No default values are necessary for this command.
Command History
Release 5.1
Release 9.1
Release 11.1
Release 17.1
Release 17.4
Release 17.5
Release A4.01
60000CRG0-35E
Displays the queueing information for the specified interface. Specify an
interface in the format <interface type [slot/port | slot/port.subinterface id |
interface id | interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For
example, for a T1 interface, use t1 0/1; for an Ethernet subinterface, use
eth 0/1.1; for a PPP interface, use ppp 1; for an ATM subinterface, use
atm 1.1; and for a wireless virtual access point, use dot11ap 1/1.1. Type
the show queue ? command to display a list of valid interfaces.
Optional. Displays the subqueue statistics.
Command was introduced.
Command was expanded to include the high level data link control (HDLC)
interface.
Demand interface was added.
Command was expanded to include the modifiers begin, exclude, and
include.
Command was expanded to include the child keyword.
Command was expanded to include the asynchronous transfer mode (ATM)
and Frame Relay interfaces.
Command was expanded to include the Metro Ethernet Forum (MEF) Metro
Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
713