ADTRAN AOS Version R10.1.0 Command Reference Manual page 754

Command Reference Guide
show spanning-tree root
Use the show spanning-tree root command to display information regarding the spanning-tree protocol
root. Variations of this command include:
show spanning-tree root
show spanning-tree root address
show spanning-tree root cost
show spanning-tree root detail
show spanning-tree root forward-time
show spanning-tree root hello-time
show spanning-tree root id
show spanning-tree root max-age
show spanning-tree root port
show spanning-tree root priority
show spanning-tree root priority system-id
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
address
cost
detail
forward-time
hello-time
id
max-age
port
priority
priority system-id
Default Values
No default values are necessary for this command.
60000CRG0-35E
Optional. Displays the address of the spanning-tree root.
Optional. Displays the path cost of the spanning-tree root.
Optional. Displays the spanning-tree root information in detail.
Optional. Displays the forward-time of the spanning-tree root.
Optional. Displays the hello-time of the spanning-tree root.
Optional. Displays the ID of the spanning-tree root.
Optional. Displays the maximum age of the spanning-tree root.
Optional. Displays the port of the spanning-tree root.
Optional. Displays the priority of the spanning-tree root.
Optional. Displays the priority and system-id of the spanning-tree root.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
754