ADTRAN AOS Version R10.1.0 Command Reference Manual page 681

Command Reference Guide
show monitor session
Use the show monitor session command to display information regarding a specified monitor session or to
display this information for all sessions. Variations of this command include:
show monitor session <number>
show monitor session all
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<number>
all
Default Values
No default values are necessary for this command.
Command History
Release 5.1
Release 17.1
Usage Examples
The following is sample output from the show monitor session command:
>enable
#show monitor session 1
Monitor Session 1
-----------------
Source Ports:
RX Only: None
TX Only: None
Both: eth 0/2, eth 0/3
Destination Port: eth 0/6
60000CRG0-35E
Displays information for a single specific monitor session.
Displays all sessions.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
681