ADTRAN AOS Version R10.1.0 Command Reference Manual page 218

Command Reference Guide
running-config
startup-config
usbdrive0
Default Values
No default values are necessary for this command.
Command History
Release 1.1
Release 17.7
Release 18.2
Usage Examples
The following example copies a software file (myfile.biz) to flash memory and renames it newfile.biz:
#copy xmodem flash
Destination filename? newfile.biz
Begin the Xmodem transfer now...
Press CTRL+X twice to cancel
CCCCCC
AOS is now ready to accept the file on the CONSOLE port (using the XMODEM protocol). The next step in
the process may differ depending on the type of terminal emulation software you are using. For
HyperTerminal, you will now select Transfer > Send File and browse to the file you wish to copy
myfile.biz. Once the transfer is complete, information similar to the following is displayed:
Received 531424 bytes.
Transfer complete
60000CRG0-35E
Replaces the active running configuration with a file copied from the
terminal connected to the console port.
Replaces the startup configuration with a file copied from the terminal
connected to the console port.
Copies a file from the terminal connected to the console port and saves it to
the USB flash drive memory.
Command was introduced.
Command was expanded to include the ramdisk parameter.
Command was expanded to include USB flash drive memory.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
218