ADTRAN AOS Version R10.1.0 Command Reference Manual page 751

Command Reference Guide
show spanning-tree interface <interface>
Use the show spanning-tree interface command to display spanning-tree protocol information for a
particular interface. Variations of this command include:
show spanning-tree interface <interface>
show spanning-tree interface <interface> active
show spanning-tree interface <interface> active detail
show spanning-tree interface <interface> cost
show spanning-tree interface <interface> edgeport
show spanning-tree interface <interface> priority
show spanning-tree interface <interface> rootcost
show spanning-tree interface <interface> state
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<interface>
active
active detail
cost
edgeport
priority
rootcost
state
Default Values
No default values are necessary for this command.
60000CRG0-35E
Specifies an interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface id | ap |
ap/radio | ap/radio.vap]>. For example, for a T1 interface, use t1 0/1; for an
Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; for an
ATM subinterface, use atm 1.1; and for a wireless virtual access point, use
dot11ap 1/1.1. Type show spanning-tree interface ? for a complete list of
valid interfaces.
Optional. Displays information for an active interface.
Optional. Displays detailed spanning-tree protocol information for an active
interface.
Optional. Displays only spanning-tree protocol path cost information.
Optional. Displays information for all interfaces configured as edgeports.
Optional. Displays only spanning-tree protocol priority information.
Optional. Displays only spanning-tree protocol root path cost information.
Optional. Displays only spanning-tree protocol state information.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
751