ADTRAN AOS Version R10.1.0 Command Reference Manual page 481

Command Reference Guide
show dot11 statistics interface dot11ap
Use the show dot11 statistics interface dot11ap command to display counters of an 802.11 radio and its
virtual access points (VAPs). Variations of this command include the following:
show dot11 statistics interface dot11ap <ap/radio>
show dot11 statistics interface dot11ap <ap/radio.vap>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<ap>
</radio>
<.vap>
The radio must be specified in the format <ap/radio>. For example, 2/1 indicates radio 1
on access point 2. The VAP must be specified in the format <ap/radio.vap>. For example,
2/1.1 indicates virtual access point 1 on radio 1 on access point 2.
Default Values
No default values are necessary for this command.
Command History
Release 15.1
Release 17.1
60000CRG0-35E
Specifies the wireless access point (AP). Range is 1 to 8.
Specifies the radio associated with the AP. Range is 1 to 2.
Specifies the VAP associated with the radio. Range is 1 to 8.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
481