ADTRAN AOS Version R10.1.0 Command Reference Manual page 679

Command Reference Guide
show mgcp-endpoint
Use the show mgcp-endpoint command to display configuration statistics for all configured Media
Gateway Control Protocol (MGCP) endpoints. Variations of this command include:
show mgcp-endpoint
show mgcp-endpoint verbose
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
verbose
Default Values
No default values are necessary for this command.
Command History
Release A2
Usage Examples
The following is sample output from the show mgcp-endpoint command:
#show mgcp-endpoint
Endpoint: 1
Name : aaln/1
FXS : 0/1
State : Connected
Endpoint: 2
Name : aaln/2
FXS : 0/2
State : Connected
Endpoint: 3
Name : aaln/3
FXS : 0/3
State : Connected
Endpoint: 4
Name : aaln/4
FXS : 0/4
State : Connected
60000CRG0-35E
Optional. Enables detailed messaging.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
679