ADTRAN AOS Version R10.1.0 Command Reference Manual page 265

Command Reference Guide
debug gvrp interface <interface>
Use the debug gvrp interface command to display GARP VLAN Registration Protocol (GVRP) debug
messages related to a particular interface. Debug messages are displayed (real time) on the terminal (or
Telnet) screen. Use the no form of this command to disable the debug messages. Variations of this
command include:
debug gvrp interface <interface> bpdus
debug gvrp interface <interface> vlans
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
<interface>
bpdus
vlans
Default Values
By default, all debug messages in AOS are disabled.
Command History
Release 8.1
Usage Examples
The following example displays debug messages showing GVRP configuration messages sent and
received on Ethernet interface 0/24:
>enable
#debug gvrp interface ethernet 0/24 bpdus
2000.07.31 23:15:51 GVRP BPDUS.eth 0/24: TX = (Len:2 LeaveAll) (Len:4 JoinIn Vlan:1) (End) ... SENT
2000.07.31 23:15:52 GVRP BPDUS.eth 0/24: RX = (Len:4 Empty Vlan:2) (Len:4 JoinIn Vlan:20) (end)
2000.07.31 23:15:52 GVRP BPDUS.eth 0/24: TX = (Len:4 JoinIn Vlan:1) (End) ... SENT
--MORE--
60000CRG0-35E
Activates debug messages for the specified interface. Specify an interface
in the format <interface type [slot/port | slot/port.subinterface id | interface id
| interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For example, for
a T1 interface, use t1 0/1; for an Ethernet subinterface, use eth 0/1.1; for a
PPP interface, use ppp 1; for an ATM subinterface, use atm 1.1; and for a
wireless virtual access point, use dot11ap 1/1.1. Type debug gvrp
interface ? for a complete list of applicable interfaces.
Displays debug messages showing all GVRP configuration messages sent
and received on the interface.
Displays debug messages showing all GVRP-related VLAN changes
occurring on the interface.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
265