ADTRAN AOS Version R10.1.0 Command Reference Manual page 614

Command Reference Guide Enable Mode Command Set
Functional Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to terminal length <number> on
page 837).
Usage Examples
The following example displays all IPv4 traffic statistics:
>enable
#show ip traffic
IP statistics:
Routing discards: 0
Rcvd: 15873 total, 7617 delivered
0 header errors, 0 address errors
0 unknown protocol, 0 discards
0 checksum errors, 0 bad hop counts
Sent: 8281 generated, 4459 forwarded
0 no routes, 0 discards
Frags: 0 reassemble required, 0 reassembled, 0 couldn't reassemble
0 created, 0 fragmented, 0 couldn't fragment
UDP statistics:
Rcvd: 3822 total, 0 checksum errors, 0 no port
Sent: 3822 total
TCP statistics:
Retrans Timeout Algorithm: 0
Min retrans timeout (ms): 0
Max retrans timeout (ms): 0
Max TCP Connections: 0
0 active opens, 64 passive opens, 0 failed attempts
5 establish resets, 1 establish current
3795 segments received, 4459 segments sent, 26 segments retransmitted
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 614