Command Reference Guide
Usage Examples
The following example initiates the Ethernet traceroute utility from a MEP with the ID 1 to an MEP with an
MEP ID of 201:
>enable
#traceroute ethernet 201 mep 1
Type CTRL+C to abort.
TTL 255. LTM Timeout is 5 seconds
Tracing route to
from
in
MD Level 7, vlan 0
Traceroute sent via interface eth 0/1
--------------------------------------------------------------------------------------------------------------------------------------------
Hops
Mac
PrevHop
--------------------------------------------------------------------------------------------------------------------------------------------
1
00:10:94:00:00:00
00:A0:C8:16:96:0D
3
00:10:94:00:00:05
00:10:94:00:00:04
2
00:10:94:00:00:04
00:10:94:00:00:00
4
00:10:94:00:00:06 (Eg)
00:10:94:00:00:05
Destination reached
Remember that linktrace can be a tree-structure, and is not always linear. The PrevHop for
Hop 3 in the previous example tells you the MAC of Hop 2. This gives you a way to trace
the linktrace message when a tree-structure exists. Refer to Section J.5 of IEEE 802.1ag
for more information.
60000CRG0-35E
MEPID 201 (00:10:94:00:00:06)
MEPID 1
Domain_1/MA_1
Flags
Forwarded
Forwarded
Forwarded
Terminal
Copyright © 2012 ADTRAN, Inc.
Ingress-Action
Egress-Action
InNoTLV
EgOK
InNoTLV
EgOK
InNoTLV
EgOK
InNoTLV
Enable Mode Command Set
Relay Action
RLY_MPDB
RLY_MPDB
RLY_MPDB
RLY_HIT
842