ADTRAN AOS Version R10.1.0 Command Reference Manual page 356

Command Reference Guide
debug save
Use the debug save command to perform a persistent save of the debug filters enabled in the current
command line interface (CLI) session. The saved filters can be restored at a later time.
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 17.4
Functional Notes
This command is used to save debug filters across a unit reboot. Filters are restored using the command
debug restore on page
debugging saved-filters command (refer to
Only one set of filters can be saved per instance of AOS. If a previous set of filters has been saved, issuing
the debug save command overwrites the previously saved filters with the current set of filters. If no filters
are currently active, issuing debug save has no effect so that the last saved files are not lost.
Usage Examples
The following example saves the debug filters from the current CLI session:
>enable
#debug save
Saving debug filters enabled in this session...
debug mail-client agent
debug probe test1
Done.
60000CRG0-35E
Command was introduced.
355. To view the saved filters without restoring them to the unit, use the show
show debugging on page
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
463).
356