ADTRAN AOS Version R10.1.0 Command Reference Manual page 547

Command Reference Guide
show ip ffe source-port <port> ingress <interface>
show ip ffe type <type>
show ip ffe type <type> egress <interface>
show ip ffe type <type> ingress <interface>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
destination <ip address>
destination-port <port>
details
egress <interface>
egress ipsec <rapidroute interface ID>
icmp-type <type>
60000CRG0-35E
83.
Optional. Filters output by a destination IP address. IP
addresses should be expressed in dotted decimal notation (for
example, 10.10.10.1).
Optional. Filters output by destination Transmission Control
Protocol (TCP) or User Datagram Protocol (UDP) port. Ports
range from 0 to 65535.
Optional. Displays detailed information. Refer to the Functional
Notes for more information about using the details keyword.
Optional. Displays RapidRoute entries for an egress interface.
Specify an interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface
id]>. For example, for a T1 interface, use t1 0/1; for an Ethernet
subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; for
an ATM subinterface, use atm 1.1. Type show ip ffe egress ?
for a complete list of valid interfaces.
Optional. Displays RapidRoute entries that come from an
Internet Protocol security (IPsec) security association (SA) on a
specified RapidRoute interface. RapidRoute interface
identifiers range from 1 to 16777215.
Optional. Displays RapidRoute entries using a specific Internet
Control Message Protocol (ICMP) type. There are three types
of ICMP to choose from:
echo Displays ICMP echo RapidRoute entries.
reply Displays ICMP reply RapidRoute entries.
0 to 255 Displays other ICMP types.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
547