ADTRAN AOS Version R10.1.0 Command Reference Manual page 766

Command Reference Guide
show tcp info
Use the show tcp info command to display Transmission Control Protocol (TCP) control block
information in AOS. This information is for troubleshooting and debug purposes only. For more detailed
information, you can optionally specify a particular TCP control block. When a particular TCP control
block is specified, the system provides additional information regarding crypto map settings that the show
tcp info command does not display. Variations of this command include:
show tcp info
show tcp info realtime
show tcp info <control block>
show tcp info <control block> realtime
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Using the realtime argument for this command can adversely affect the performance of
your unit.
Syntax Description
<control block>
realtime
Default Values
No default values are necessary for this command.
Command History
Release 4.1
Release 10.1
Release 17.1
60000CRG0-35E
Optional. Specifies a particular TCP control block for more detailed information.
Optional. Displays full-screen output in real time. Refer to the Functional
Notes below for more information.
Command was introduced.
The realtime display parameter was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
766