ADTRAN AOS Version R10.1.0 Command Reference Manual page 1088

Command Reference Guide
ip rtp quality-monitoring jitter-buffer
Use the ip rtp quality-monitoring jitter-buffer command to specify the jitter buffer type and
configuration for the jitter buffer emulator (JBE) that generates the observable jitter statistics in Realtime
Transport Protocol (RTP) quality monitoring. Use the no form of this command to return to the default
setting. Variations of this command include:
ip rtp quality-monitoring jitter-buffer
ip rtp quality-monitoring jitter-buffer adaptive min <delay> nominal <value>
ip rtp quality-monitoring jitter-buffer adaptive min <delay> nominal <value> max <value>
ip rtp quality-monitoring jitter-buffer fixed nominal <value> jitter-buffer-size <value>
Syntax Description
adaptive min <delay>
nominal <value>
max <value>
fixed nominal <value>
jitter-buffer-size <value>
Default Values
By default, the jitter buffer is set to adaptive min 10 nominal 50 max 200.
Command History
Release 17.1
Release A1
Release A4.01
Usage Examples
The following example enables the JBE to hold up to 175 packets in fixed mode:
(config)#ip rtp quality-monitoring jitter-buffer fixed nominal 50 jitter-buffer-size 175
60000CRG0-35E
Optional. Specifies the minimum acceptable jitter buffer delay to be used by
the JBE. The range is 10 to 240 milliseconds.
Optional. Specifies the starting delay applied to packets of the emulated
jitter buffer. The range is 10 to 240 milliseconds.
Optional. Specifies the maximum delay that the adaptive jitter buffer will be
allowed to use. The range is 40 to 320 milliseconds.
Optional. Specifies the actual fixed delay that would be applied to the
packet in a nonemulated jitter buffer. The range is 4 to 250 milliseconds.
There is no default setting.
Optional. Specifies the number of packets that the emulated jitter buffer can
hold. The range is 10 to 500 packets. There is no default setting.
Command was introduced.
Command was introduced in the AOS voice products.
Command was modified to allow specifying the nominal value without
specifying the max value.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1088