ADTRAN AOS Version R10.1.0 Command Reference Manual page 238

Command Reference Guide
debug dialup-interfaces
Use the debug dialup-interfaces command to generate debug messages used to aid in troubleshooting
problems with all dialup interfaces, such as the modem or the basic rate interface (BRI) cards. Debug
messages are displayed (real time) on the terminal (or Telnet) screen. Use the no form of this command to
disable the debug messages.
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
No subcommands.
Default Values
By default, all debug messages in AOS are disabled.
Command History
Release 2.1
Functional Notes
When enabled, these messages provide status information on incoming calls, dialing and answering
progress, etc. These messages also give information on why certain calls are dropped or rejected. It is
beneficial to use this command when troubleshooting dial backup (in addition to the debug dial-backup
command).
Usage Examples
The following example activates the debug messages for dialup interfaces:
>enable
#debug dialup-interfaces
60000CRG0-35E
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
238