ADTRAN AOS Version R10.1.0 Command Reference Manual page 151

Command Reference Guide
clear mac address-table dynamic
Use the clear mac address-table dynamic command to remove dynamic medium access control (MAC)
addresses from the MAC address table. Variations of this command include:
clear mac address-table dynamic <interface>
clear mac address-table dynamic address <mac address>
Syntax Description
<interface>
address <mac address>
Default Values
No default values are necessary for this command.
Command History
Release 5.1
Usage Examples
The following example removes the dynamic address A0:B1:C2:D3:E4:A1 from the MAC address table:
>enable
#clear mac address-table dynamic address A0:B1:C2:D3:E4:A1
The following example removes all dynamic addresses from the MAC address table:
>enable
#clear mac address-table dynamic
60000CRG0-35E
Removes the MAC address of the specified interface. Specify an interface
in the format <interface type [slot/port | slot/port.subinterface id | interface id
| interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For example, for
a T1 interface, use t1 0/1; for an Ethernet subinterface, use eth 0/1.1; for a
PPP interface, use ppp 1; for an ATM subinterface, use atm 1.1; and for a
wireless virtual access point, use dot11ap 1/1.1. Type clear mac
address-table dynamic interface ? for a complete list of applicable
interfaces.
Removes a specific MAC address from the table. MAC addresses should
be expressed in the following format xx:xx:xx:xx:xx:xx (for example,
00:A0:C8:00:00:01).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
151