ADTRAN AOS Version R10.1.0 Command Reference Manual page 144

Command Reference Guide
<protocol>
<ipv6 source>
<source port>
<ipv6 destination>
<destination port>
<interface>
<id>
<type/code>
vrf <name>
Default Values
No default values are necessary for this command.
Command History
Release 18.1
Release R10.1.0
Functional Notes
The second half of this command, beginning with the source IPv6 address, can be copied and pasted from
a row in the show ipv6 policy-sessions table for easier use.
VRF on AOS products allows a single physical router to be partitioned into multiple virtual routers. Each
router instance has its own route table and interface assignments. Beginning with Release 16.1, all AOS
routers supporting multiple VRF instances (multi-VRF) have an unnamed default VRF instance regardless
of whether multi-VRF is configured. Therefore, executing the abovementioned commands without
specifying a VRF will only affect the default unnamed VRF.
60000CRG0-35E
Specifies a protocol. Valid range is 0 to 255.
Specifies the source IPv6 address. IPv6 addresses should be expressed in
colon hexadecimal notation (X:X:X:X::X). For example, 2001:DB8:1::1.
Specifies the source port for TCP and UDP sessions. Range is 0 to 65535.
Specifies the destination IPv6 address. IPv6 addresses should be
expressed in colon hexadecimal notation (X:X:X:X::X). For example,
2001:DB8:1::1.
Specifies the destination port for TCP and UDP sessions. Range is 0 to
65535.
Specifies the interface when a link-local IPv6 address is entered (addresses
beginning with FE80::). Interfaces must be entered when using a link-local
address. Specify interfaces in the <interface> <slot/port | interface id>
format. For example, to specify a Point-to-Point Protocol (PPP) interface,
enter ppp 1.
Specifies the ICMPv6 ID. Valid range is 0 to 65535.
Specifies the type and code of the ICMPv6 session to be cleared. Type and
code ranges are 0 to 255.
Optional. Specifies the VRF instance to impact. Executing the
abovementioned commands without specifying a VRF will only affect the
default unnamed VRF.
Command was introduced.
Command was expanded to include the tunnel interface and the pending
parameter.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
144