ADTRAN AOS Version R10.1.0 Command Reference Manual page 159

Command Reference Guide
clear port-security violation-count <interface>
Use the clear port-security violation-count command to clear the violation count associated with a
particular interface.
Syntax Description
<interface>
Default Values
No default values are necessary for this command.
Command History
Release 8.1
Usage Examples
The following command clears the violation count associated with the Ethernet interface 0/1:
>enable
#clear port-security violation-count eth 0/1
60000CRG0-35E
Clears the information for the specified Ethernet interface. Specify an
interface in the format <interface type [slot/port | slot/port.subinterface id |
interface id | interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For
example, for a T1 interface, use t1 0/1; for an Ethernet subinterface, use
eth 0/1.1; for a PPP interface, use ppp 1; for an ATM subinterface, use
atm 1.1; and for a wireless virtual access point, use dot11ap 1/1.1. Type
clear port-security violation-count interface ? for a complete list of
applicable interfaces.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
159