Command Reference Guide
clear counters <interface>
Use the clear counters command to clear all interface counters (or the counters for a specified interface).
Syntax Description
<interface>
Default Values
No default values are necessary for this command.
Command History
Release 1.1
Release 9.1
Release A4.01
Release A5.01
Usage Examples
The following example clears all counters associated with the Ethernet 0/1 interface:
>enable
#clear counters ethernet 0/1
60000CRG0-35E
Specifies an interface in the format <interface type [slot/port |
slot/port.subinterface id | interface id | interface id.subinterface id | ap |
ap/radio | ap/radio.vap]>. For example, for a T1 interface, use t1 0/1; for an
Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; for an
ATM subinterface, use atm 1.1; and for a wireless virtual access point, use
dot11ap 1/1.1. Type clear counters ? or show interface ? for a complete
list of interfaces.
Command was introduced.
Command was expanded to include the high level data link control (HDLC)
and tunnel interfaces.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface and the Gigabit Switchport interface.
Command was expanded to include the Gigabit Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
95